Solved

QOS IN A LAN NETWROK

Posted on 2008-10-06
4
842 Views
Last Modified: 2012-05-05
I want to setup QOS in our LAN network where there isn't any voice traffic. But we got important traffic that needs priority. We have 2960 and 6509-Eseries running HSRP and OSPF.
0
Comment
Question by:VRRDANDU
  • 2
  • 2
4 Comments
 
LVL 10

Expert Comment

by:atlas_shuddered
ID: 22653737
0
 

Author Comment

by:VRRDANDU
ID: 22657426
Hi thanks for the Help, but i got those files.

I tried configuring qos on the 2960, tried classification using  mac-access list and normal access-list and then tried to mark the packets using dscp. Then i tried to monitor the packets but i cant find any markings on the packets . So could you give me a sample config  for a 2960.

Regards,
Rams
0
 
LVL 10

Accepted Solution

by:
atlas_shuddered earned 500 total points
ID: 22659878
Two questions, is any routing being performed in the topology?

Second, if not, how are you marking your packets as they traverse from your source?

You will either need to figure out a way to mark every packet leaving your devices (QoS Packet Scheduling?) or roll them through a routed interface so that you can identify the packet (switches only care about the frame unless layer three enable and configured) and mark/schedule as necessary.

Cheers
0
 

Author Comment

by:VRRDANDU
ID: 22667110
Yes we got routing enabled on layer3 interfaces (OSPF) in 6509E-series, but i am marking the packets on 2960 with COS vlaues. but after re reading the PDF u send i tried and it did work good.

Thanks for the help, in anycase can you help me out with some sample config of qos for 6509 and 2960 to just verify about the queue settings.

Cheers,
0

Featured Post

Connect further...control easier

With the ATEN CE624, you can now enjoy a high-quality visual experience powered by HDBaseT technology and the convenience of a single Cat6 cable to transmit uncompressed video with zero latency and multi-streaming for dual-view applications where remote access is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Fortigate 100D NTP Issue 4 104
Read-only SNMP string example ? 7 100
ssh setup on Cisco swith 11 86
Is WiFi half-duplex or Full -duplex 4 58
This article is a step by step guide on how to create a basic PTP link using Ubiquiti airOS devices. This guide can be used on the following Ubiquiti AirMAX devices. Nanostation, Bullets, AirBridge, Nanobeam, NanoBridge to name a few. Please review …
If you are thinking of adopting cloud services, or just curious as to what ‘the cloud’ can offer then the leader according to Gartner for Infrastructure as a Service (IaaS) is Amazon Web Services (AWS).  When I started using AWS I was completely new…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

790 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question