Solved

configure cisco 2801 external adsl modem

Posted on 2008-10-08
4
858 Views
Last Modified: 2013-12-27
Have external dsl modem - how do I set up the ppoe authentication to the ethernet interface on the router to get it to dial out and begin traffic flow?
0
Comment
Question by:cortafuegos
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
4 Comments
 
LVL 26

Accepted Solution

by:
Soulja earned 250 total points
ID: 22673652
0
 
LVL 79

Expert Comment

by:lrmoore
ID: 22677799
If you want to do PPoE authentication on the router, check out the configuration guide here. Concept is same for 837 or 2801..
http://www.cisco.com/en/US/docs/routers/access/800/820/software/configuration/guide/netscene.html#wp1066031
0
 

Author Comment

by:cortafuegos
ID: 23339747
no comment - help was probably as good as it gets since this is apparently a fairly rare situation. If it wasn't, I'm sure there would have been some more interest in lending a hand.
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Setting up a VPN 60 207
Connecting to CISCO 4402 WLC 3 54
Home network with two AP's dropping WiFi connectivity 12 88
Mac address in Nexus7K fex port 5 17
In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
Before I go to far, let's explain HA (High Availability) and why you should consider it.  High availability is the mechanism used to provide redundancy to any service at the same site and appears as a single service to the users of that service.  As…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

730 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question