• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 7724
  • Last Modified:

How do you Configure Port Channel on Cisco 3560?

How would i configure port channel on a 3560 switch?  The two swithes are running layer 3 IOS.  I want to use 2 of the gig interfaces as port channels and use HSRP btwn them.

Thanks,

0
donemore2003
Asked:
donemore2003
1 Solution
 
kyleb84Commented:
Switch #1:

interface Port-channel 1
 switchport mode access no ip address snmp trap link-status!
!
interface GigabitEthernet0/1
 switchport mode access
 no ip address
 snmp trap link-status
 channel-group 1 mode desirable
!
interface GigabitEthernet0/2
 switchport mode access
 no ip address
 snmp trap link-status
 channel-group 1 mode desirable
!

Switch #2:
Copy from Switch #1.

You'll need IP addresses on the Vlan1 interface that are in the same network to allow management of the link.

NOTE:
This is a Layer 2 Port Channel.

Layer 3 Channel:
http://www.cisco.com/en/US/products/hw/switches/ps672/products_tech_note09186a0080093dca.shtml
0

Featured Post

Vote for the Most Valuable Expert

It’s time to recognize experts that go above and beyond with helpful solutions and engagement on site. Choose from the top experts in the Hall of Fame or on the right rail of your favorite topic page. Look for the blue “Nominate” button on their profile to vote.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now