Solved

Unable to establish VPN

Posted on 2008-10-10
2
629 Views
Last Modified: 2012-06-21
I am trying to configure a VPN between a 5510 and draytek or a zyxel, neither of which will work. I get the following messages

Error; Unable to remove PeerTblEntry

Removing peer from peer table failed, no match!
error processing payload: Payload ID: 1

I have tried every type of encryption to no avail.

Any ideas
0
Comment
Question by:wanstor
2 Comments
 
LVL 63

Expert Comment

by:SysExpert
ID: 22687410
1) Do you have the latest firmware on all devices ?

2) have you matched te Phase 1 and phase 2 setups exactly ?

3) Are you using the same pre-shared key or certificates ?


I hope this helps !
0
 
LVL 1

Accepted Solution

by:
wanstor earned 0 total points
ID: 22687525
It wasn't liking stand alone routers.  I configured a PIX on the other end and it came straight up.
0

Featured Post

Netscaler Common Configuration How To guides

If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This is an article about my experiences with remote access to my clients (so that I may serve them) and eventually to my home office system via Radmin Remote Control. I have been using remote access for over 10 years and have been improving my metho…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…

920 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

18 Experts available now in Live!

Get 1:1 Help Now