?
Solved

question about needed FXO card for Cisco 2821 CME

Posted on 2008-10-16
1
Medium Priority
?
626 Views
Last Modified: 2012-08-13
We have a Cisco 2821 router running callmanager express for our secondary location which just had an intergrated T1 installed which provides the T1 with 7 POTS lines broken out to a 66 block.  Will two 4 port FXO cards (VIC2-4FXO) be all I need to add the lines?  Or do I need this card (VIC-4FXS/DID)?
http://www.cisco.com/en/US/products/hw/voiceapp/ps967/products_data_sheet09186a00800a953b.html

If anyone knows a better way to get the POTS lines to the 2821 please advise.
0
Comment
Question by:cambee72
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 79

Accepted Solution

by:
lrmoore earned 2000 total points
ID: 22736026
Yes, you need the FXO cards, not the FXS

0

Featured Post

Portable, direct connect server access

The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In this tutorial I will show you with short command examples how to obtain a packet footprint of all traffic flowing thru your Juniper device running ScreenOS. I do not know the exact firmware requirement, but I think the fprofile command is availab…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

762 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question