Solved

Idiot's Guide to Creating VPN tunnels on RV082

Posted on 2008-10-20
2
661 Views
Last Modified: 2012-05-05
I have a RV082 Linksys router.  I plan to deploy 1 at each of my 3 locations.  I need help on setting up Location A to accept the connections of the other locations.  Specifically the Tunnel settings to use.  I have a static IP at Location A and the two satellites are dynamic.  

I cannot seem to find any information on the most basic of setup formats.  Any help is greatly appreciated.
0
Comment
Question by:Matt Lennertz
2 Comments
 
LVL 7

Accepted Solution

by:
willbaclimon earned 500 total points
ID: 22768401
0
 

Author Comment

by:Matt Lennertz
ID: 22790206
For those as novice as I was with VPN, one key thing to note is that you need to have a different IP address range AND subnet mask for the client(s), than you do for the gateway.

if your host location is 192.168.1.1 and 255.255.255.0

Than your client needs to be 192.168.2.1 and 255.255.255.192 for example.

thanks for the help.
0

Featured Post

Why You Should Analyze Threat Actor TTPs

After years of analyzing threat actor behavior, it’s become clear that at any given time there are specific tactics, techniques, and procedures (TTPs) that are particularly prevalent. By analyzing and understanding these TTPs, you can dramatically enhance your security program.

Join & Write a Comment

When you connect to your workplace's VPN, you may not notice that you are using your workplace's servers to serve up webpages.  This might be undesirable since the workplace can log all the places you've been.  It also might be very slow to load pag…
Overview Often, we set up VPN appliances where the connected clients are on a separate subnet and the company will have alternate internet connections and do not use this particular device as the gateway for certain servers or clients. In this case…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

746 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

10 Experts available now in Live!

Get 1:1 Help Now