How to configure the IP and IPSEC in pix 501

hey everyone,

i want to setup my pix 501 firewall to the following

EXT ip 85.324.127.164
and internal ip 172.31.185.0/24

how can i do it? my ip address for pix is 172.31.181.14 i did the tel net and used

ip address outside 85.324.127.164 255.255.255.248
ip address inside 172.31.185.12 255.255.255.0

is this correct what i did?

secondly i want to have a IPSEC

IPSEC PHASE I - 3DES/SHA1/GROUP2()1024 BIT
IPSEC PHASE II 3DES/SHA1/PFS-GROUP 2
Pre-shared key 4mm4r

how can i do that please help
ammartahir1978Asked:
Who is Participating?
 
gratex_ssdConnect With a Mentor Commented:
2) IPSEC - VPN
read this if you want client VPN to PIX
http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a00801e71c0.shtml

or this if you want site-2-site VPN
http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094761.shtml

1) yes, you set adresses corectly if the MASK at outside interface is correct...
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.