Go Premium for a chance to win a PS4. Enter to Win

x
?
Solved

Router to PIX VPN failover over DSL

Posted on 2008-10-22
2
Medium Priority
?
377 Views
Last Modified: 2012-06-27
Hello.

I have 2 sites. Site A is connected to the internet via an E1 and Site B which is also connected to the internet via an E1.
I am currently running an IPSEC vpn tunnel between a PIX 515E at site A and a Cisco 2610 at site B.

I have been having problems with the E1 provided to site B and want to be able to create a backup VPN over DSL should I have further issues.

I have a WIC card within the 2610 at site B. This is connected to DSL and has a Fixed IP address.
The failover will need to be from the PIX at site A to the DSL connection at site B.

I seem to be having problems setting this up so any help would be very much appreciated!

Thanks guys,

Scott259
0
Comment
Question by:scott259
2 Comments
 
LVL 79

Accepted Solution

by:
lrmoore earned 2000 total points
ID: 22791748
If you just setup the PIX to look like there are two different peers for the same traffic, it will use the one with the lowest priority number and the next one if necessary:

Something like this:

rypto map outside_map 10 match address outside_1_cryptomap
crypto map outside_map 10 set peer <T1 ip address>
crypto map outside_map 10 set transform-set ESP-3DES-MD5
rypto map outside_map 20 match address outside_1_cryptomap
crypto map outside_map 20 set peer <DSL ip address>
crypto map outside_map 20 set transform-set ESP-3DES-MD5
0

Featured Post

Ready for your healthcare security check-up?

In the past few years, healthcare organizations have become a prime target for advanced attacks. Does your organization have what it needs to defend itself? Schedule your healthcare security check-up today and download our free Healthcare Security Resource Kit today!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article is in regards to the Cisco QSFP-4SFP10G-CU1M cables, which are designed to uplink/downlink 40GB ports to 10GB SFP ports. I recently experienced this and found very little configuration documentation on how these are supposed to be confi…
In this article, the configuration steps in Zabbix to monitor devices via SNMP will be discussed with some real examples on Cisco Router/Switch, Catalyst Switch, NAS Synology device.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
As a trusted technology advisor to your customers you are likely getting the daily question of, ‘should I put this in the cloud?’ As customer demands for cloud services increases, companies will see a shift from traditional buying patterns to new…

916 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question