Solved

Configuring Cisco 826

Posted on 2008-10-22
1
290 Views
Last Modified: 2013-12-14
Hi Experts,

I have a Cisco 826 router that I would like to configure and connect it to my ISP.
The following are some of the required information:

LAN: 192.168.1.1
Subnet: 255.255.255.0
DHCP enable: 192.168.1.50 - 192.168.1.100


User Name: XXXXX
Password: XXXXX
Virtual circuit: Pvc0
Connection Type: PPoE
WAN IP: XX.XXX.XXX.XXX
Subnet: 255.255.255.255
Gateway:  XX.XXX.XXX.XXX
DNS Server:  XX.XXX.XXX.XXX
Default Gateway:  XX.XXX.XXX.XXX

Thanks in advance
mcse2007


0
Comment
Question by:mcse2007
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 5

Accepted Solution

by:
rexxus earned 350 total points
ID: 22785370
Two options, one is to configure via the CLI, the other is to configure via your browser.

If the box has default config on it, power it up and connect a PC to ethernet interface and once you've got an IP address from DHCP open a browser and point it to http://10.10.10.1 

From there you should be able to configure it by following the prompts in the gui.
0

Featured Post

Increase Agility with Enabled Toolchains

Connect your existing build, deployment, management, monitoring, and collaboration platforms. From Puppet to Chef, HipChat to Slack, ServiceNow to JIRA, Splunk to New Relic and beyond, hand off data between systems to engage the right people.

Connect with xMatters.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

717 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question