Solved

how to add additional network card using PROM ?

Posted on 2008-10-23
5
202 Views
Last Modified: 2013-12-27
how can I add addition network card using OBP and then do a network boot ?
0
Comment
Question by:beer9
  • 3
  • 2
5 Comments
 
LVL 40

Expert Comment

by:omarfarid
Comment Utility
simply power off the system, add the card, power on then from ok prompt run

boot net
0
 

Author Comment

by:beer9
Comment Utility
if I have to network card then how it will recognize from which to boot.
I want to make right one default bootable net device.. how to do that ?
0
 
LVL 40

Expert Comment

by:omarfarid
Comment Utility
Do you have more than one boot server on your networks? If not then boot net will boot from that one.
0
 

Author Comment

by:beer9
Comment Utility
typo

if I have *two* network card then how it will recognize from which to boot.
I want to make right one default bootable net device.. how to do that ?
0
 
LVL 40

Accepted Solution

by:
omarfarid earned 125 total points
Comment Utility
I think it does that one by one.
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

This tech tip describes how to install the Solaris Operating System from a tape backup that was created using the Solaris flash archive utility. I have used this procedure on the Solaris 8 and 9 OS, and it shoudl also work well on the Solaris 10 rel…
Using libpcap/Jpcap to capture and send packets on Solaris version (10/11) Library used: 1.      Libpcap (http://www.tcpdump.org) Version 1.2 2.      Jpcap(http://netresearch.ics.uci.edu/kfujii/Jpcap/doc/index.html) Version 0.6 Prerequisite: 1.      GCC …
Learn how to navigate the file tree with the shell. Use pwd to print the current working directory: Use ls to list a directory's contents: Use cd to change to a new directory: Use wildcards instead of typing out long directory names: Use ../ to move…
In a previous video, we went over how to export a DynamoDB table into Amazon S3.  In this video, we show how to load the export from S3 into a DynamoDB table.

762 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

9 Experts available now in Live!

Get 1:1 Help Now