Solved

port security

Posted on 2008-10-24
4
302 Views
Last Modified: 2010-04-12
VLAN10 ports assigned 1-5, port 1 its a external VPN connection, i want port 1 to be access to port 2-5 only, how is it possible from catalyst 3548 switch
0
Comment
Question by:ammadeyy2020
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 3
4 Comments
 
LVL 50

Expert Comment

by:Don Johnston
ID: 22795746
>how is it possible from catalyst 3548 switch

It already is. The only ports that can send/receive to port 1 are ports 2-5 since they're the only ports in VLAN10.
0
 
LVL 50

Expert Comment

by:Don Johnston
ID: 22795759
Sorry. Didn't notice that you had two routers at HQ. So you'll want HSRP at both locations.

Still need the LAN topology and IP addresses.
0
 

Author Comment

by:ammadeyy2020
ID: 22796035
is it possible to do vlan and port security on same port?

anyway i created a seperate vlan for vpn and create acl that vpn user are able to access to vlan 10 only
0
 
LVL 50

Accepted Solution

by:
Don Johnston earned 500 total points
ID: 22796184
>is it possible to do vlan and port security on same port?

Yes.
0

Featured Post

Free Tool: SSL Checker

Scans your site and returns information about your SSL implementation and certificate. Helpful for debugging and validating your SSL configuration.

One of a set of tools we are providing to everyone as a way of saying thank you for being a part of the community.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
Arrow Electronics was searching for a KVM  (Keyboard/Video/Mouse) switch that could display on one single monitor the current status of all units being tested on the rack.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

726 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question