Solved

failover, Load balancing, Cisco CEF

Posted on 2008-10-24
3
1,295 Views
Last Modified: 2011-10-19
I have a cisco 1841 router. Bonded T1 and cable from two different providers. I would like to Load balance OR more importnatly Fail over if on link should fail.
Here is my problem. On my inside interface, i have a few secondary IP address assinged (for multiple gateways for mulpitle networks) [I.E. 10.0.2.1, 10.0.3.1 etc.]
All IP's are NATed for external tracfic. how would i fail over or balance the Nated Set up?
The cable will be attetched to the free Ethernet port. (FA0/1)

Attatched is the full config for this router.

SDMConfig.txt
0
Comment
Question by:Direrayne
  • 2
3 Comments
 
LVL 5

Accepted Solution

by:
mr_dirt earned 500 total points
ID: 22797205
NAT load balancing with IOS for two Internet connections is explained by a doc on cisco.com, here:

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a0080950834.shtml

I'm not sure if the configuration will address the secondary addresses on the router.  Are you running multiple IP subnets in one layer two domain?  This strikes me as bad design.
0
 

Author Comment

by:Direrayne
ID: 22799674
0
 

Author Closing Comment

by:Direrayne
ID: 31509688
You are awesome!!!
0

Featured Post

NAS Cloud Backup Strategies

This article explains backup scenarios when using network storage. We review the so-called “3-2-1 strategy” and summarize the methods you can use to send NAS data to the cloud

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Getting hacked is no longer a matter or "if you get hacked" — the 2016 cyber threat landscape is now titled "when you get hacked." When it happens — will you be proactive, or reactive?
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
To efficiently enable the rotation of USB drives for backups, storage pools need to be created. This way no matter which USB drive is installed, the backups will successfully write without any administrative intervention. Multiple USB devices need t…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

825 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question