FWeston
asked on
Cisco 1841 back-to-back SHDSL config
I have two 1841 routers with WIC-1SHDSL-V2 interfaces and I want to configure the DSL WICs back to back to network two buildings together. The buildings are about 1000' apart and we have a copper pair between them.
I found a Cisco article (http://www.cisco.com/en/US/tech/tk175/tk274/technologies_configuration_example09186a0080135834.shtml) however I haven't been able to get these configs to work and I assume it's because they are for different router models.
The WICs are detected on both routers and I am able to get the DSL controllers to link up, but am not sure what I need to do to address them and get IP working.
I found a Cisco article (http://www.cisco.com/en/US/tech/tk175/tk274/technologies_configuration_example09186a0080135834.shtml) however I haven't been able to get these configs to work and I assume it's because they are for different router models.
The WICs are detected on both routers and I am able to get the DSL controllers to link up, but am not sure what I need to do to address them and get IP working.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.