Still celebrating National IT Professionals Day with 3 months of free Premium Membership. Use Code ITDAY17

x
?
Solved

ip nat inside source list 1 interface FastEthernet4 overload

Posted on 2008-10-27
4
Medium Priority
?
2,004 Views
Last Modified: 2012-05-05
I am looking over my running config on my router and see: ip nat inside source list 1 interface FastEthernet4 overload.  What does this mean?  

I have to admit that I used to know all the Cisco stuff but cannot remember it because it has been like 6 years since I was involved in computer networking and have just recently gotten back into it.  
0
Comment
Question by:aclaus225
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
  • 2
4 Comments
 
LVL 3

Expert Comment

by:mrwalker15
ID: 22814471
This command enables translation on the inside address using access-list 1. the overload command enables the router to use one global address to many internal address. Also known as PAT or Hide NAT.
0
 

Author Comment

by:aclaus225
ID: 22814547
So, this is not actually like an error message, but a command that is on the router?  
0
 
LVL 3

Accepted Solution

by:
mrwalker15 earned 1000 total points
ID: 22814582
Correct. It is a NAT command.

You dont get error messages when you show running-configuration.
0
 

Author Closing Comment

by:aclaus225
ID: 31510402
I realized this after I posted the question.  Thanks for your help.  
0

Featured Post

Supports up to 4K resolution!

The VS192 2-Port 4K DisplayPort Splitter is perfect for anyone who needs to send one source of DisplayPort high definition video to two or four DisplayPort displays. The VS192 can split and also expand DisplayPort audio/video signal on two or four DisplayPort monitors.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

On Feb. 28, Amazon’s Simple Storage Service (S3) went down after an employee issued the wrong command during a debugging exercise. Among those affected were big names like Netflix, Spotify and Expedia.
This article is in regards to the Cisco QSFP-4SFP10G-CU1M cables, which are designed to uplink/downlink 40GB ports to 10GB SFP ports. I recently experienced this and found very little configuration documentation on how these are supposed to be confi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

670 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question