Solved

Installing NM-2FE2W-V2 card

Posted on 2008-10-30
3
1,404 Views
Last Modified: 2008-11-04
I'm trying to install "NM-2FE2W-V2" card in Cisco 2600 Series router. But the card is not being detected. Please suggest.

Thanks
0
Comment
Question by:valuelabs97
  • 2
3 Comments
 
LVL 5

Assisted Solution

by:rexxus
rexxus earned 125 total points
ID: 22840688
From table 3 on the following page

http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet09186a00801aa71c.html

That module isn't supported in the 2600 series (unless it's a 2691)
0
 

Accepted Solution

by:
valuelabs97 earned 0 total points
ID: 22840795
Thanks Rexxus. I want to add 2 more FE ports to 2621XM router. Could you please tell me which model NM card will work.

Thanks,
Niranjan
0
 
LVL 5

Assisted Solution

by:rexxus
rexxus earned 125 total points
ID: 22841006
From:
http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet0900aecd800fa5be.html

You're limited in upgrades, you could get 4 Ethernet ports (NM-4E), if you need FastEthernet you'd have to go to a 16 port switch module (NM-16SW), although the 16 ports are layer 2 only.

You need minimum IOS 12.2(8)T to support the NM-16SW

Info about the switch port modules:
http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet09186a00801aca3e.html
0

Featured Post

Easy, flexible multimedia distribution & control

Coming soon!  Ideal for large-scale A/V applications, ATEN's VM3200 Modular Matrix Switch is an all-in-one solution that simplifies video wall integration. Easily customize display layouts to see what you want, how you want it in 4k.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

856 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question