Solved

DHCP Client List will not refresh within Belkin Wireless G- Router

Posted on 2008-10-31
3
4,022 Views
Last Modified: 2013-11-05
I Everyone;

        I noticed the DHCP Client list will not accurately update within the configuration of my Belkin Wireless -G router even after I refresh it.  For example, the list still contains SSID's or wireless names of computers which are no longer connected to the wireless.  Is there a way I can clear this so the list accurately reflects only those computers currently connected to the wireless?

       Thank you.

      George
0
Comment
Question by:GMartin
  • 2
3 Comments
 
LVL 14

Accepted Solution

by:
Kutyi earned 500 total points
ID: 22855866
power it off and on then renew your PCs IP address with the command ipconfig /renew
0
 

Author Closing Comment

by:GMartin
ID: 31512245
Hi There;

       Thank you so much for your suggestion.  I worked "perfectly".  Your solution was exactly what I needed.  The DHCP list is now an accurate representation of the wireless connections.

         Many thanks once again for a job so well done.

        George
0
 
LVL 14

Expert Comment

by:Kutyi
ID: 22860158
Glad to help!.....:)
0

Featured Post

Live: Real-Time Solutions, Start Here

Receive instant 1:1 support from technology experts, using our real-time conversation and whiteboard interface. Your first 5 minutes are always free.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
How do I modify Ubigate for new ISP? 2 92
New TWC modem/router breaks network 53 113
Port Forwarding on Cisco 881 14 57
Network Vs Redistribute Connected Commands 3 7
While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

785 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question