Solved

network is slow through them and slow web gui

Posted on 2008-11-01
2
481 Views
Last Modified: 2012-08-13
We have 2 Linksys switches SRW224G4 and the network is very slow through them and web gui impposible to use.
Will call Linksys, but just looking to see if anybody else have experienced same issues, if its a known issue or we just been unlucky with them.
0
Comment
Question by:itmti
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 11

Accepted Solution

by:
grsteed earned 500 total points
ID: 22857788
Sounds like you may have a Duplex Mismatch.  There's a known problem on 100 Mb ports and they have to be set the same on both sides, either auto/auto or fixed 100/full. If you have them set with auto on one side and fixed on the other, the auto end will come up half duplex and cause problems.

Look at the Ethernet stats on all of the ports see if you are getting collisions.

Cheers,
Gary
0
 

Author Comment

by:itmti
ID: 22858115
I will try to check, which is hard because web gui never loads or i have to unplug all computers and reboot the switch just leave my laptop on.

This is remote office not critical so we bought these linksys switches for them, but I guess we should have invested in something better.  
In another remote offices we started putting 3com 3CBLSG48 cheap switches, seems to work much better, GUI loads and performance much better.

Thank you for suggesstion i will take a look at port configs.
0

Featured Post

Optimize your web performance

What's in the eBook?
- Full list of reasons for poor performance
- Ultimate measures to speed things up
- Primary web monitoring types
- KPIs you should be monitoring in order to increase your ROI

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I eventually solved a perplexing problem setting up telnet for a new switch.  I installed a new Cisco WS-03560X-24P switch connected to an existing Cisco 4506 running a WS-X4013-10GE Sup II-Plus. After configuring vlans and trunking,  I could no…
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
In this video we outline the Physical Segments view of NetCrunch network monitor. By following this brief how-to video, you will be able to learn how NetCrunch visualizes your network, how granular is the information collected, as well as where to f…
In this video you will find out how to export Office 365 mailboxes using the built in eDiscovery tool. Bear in mind that although this method might be useful in some cases, using PST files as Office 365 backup is troublesome in a long run (more on t…

623 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question