asked on

Failover of echange 2007 CCR

I have 2 servers which are setup in a cluster with a cross cable connecting them. The exchange 2007 MB role is installed. When I move the storage groups from one server to the next the failover works but if I run eseutil /mh it shows that the storage groups on each server are in a dirty shutdown state. The routing of mail works fine nd users have no problem but how do I get it to say clean shutdown. I donot want to use eseutil /p.

Exchange_Geek

First of all, how do you intend to fail over between these clusters - using shell / cluster admin console?
If you end up with eseutil /mh - dirty shutdown, Next most valuable information to check is log file required status.
If this shows an information about certain number of log files (which are present on the server including e00.log) - you may run the eseutil /r "path to the e00.log"
This should bring the database to clean shutdown state and definitely mountable.

Hope this helps.

grouptandi

ASKER

After running the eseutil /r command i got the following error:
Any other suggestions?

[PS] T:\Program Files\Microsoft\Exchange Server\Mailbox\Silver>eseutil /r e03
Extensible Storage Engine Utilities for Microsoft(R) Exchange Server
Version 08.00
Copyright (C) Microsoft Corporation. All Rights Reserved.
Initiating RECOVERY mode...
Logfile base name: e03
Log files: <current directory>
System files: <current directory>
Performing soft recovery...
Operation terminated with error -528 (JET_errMissingLogFile, Current log file missing) after 0.16 seconds.

ASKER CERTIFIED SOLUTION

Exchange_Geek

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial