I must configure a T1 line on a Cisco 1841 router that will be shipped to the USA. I live in europe and have a little experience how to configure a T1 line.
I have installed the card (VWIC2-1MFT-T1/E1) and is activated with the command "card t1 0 0". I can see the card in the running config but how can I configure the interface? I can't see the interface if I do a "show ip int brief".
And can someone send my a example of a configuration because I don't now what to use(framing, linecode, timeslots, channel-group, tdm-group). The provider is Earthlink.