Interface in Auto Shutdown... how to bring it back up?

My PIX seemed to be acting strangely as my SYSLOG was not geting any messages.  I went in and looked at the Running Config and I see this line of code:
interface ethernet1 auto shutdown
Of course when operating normally it says:
interface ethernet1 100full

What command, or series of commands, should I issue to correct this.  When looing at the various inetrface command options (via an "inteface ?" input at on command line), it doesn't look like "noshut" is a valid option.

Any advice?
Who is Participating?
I wear a lot of hats...

"The solutions and answers provided on Experts Exchange have been extremely helpful to me over the last few years. I wear a lot of hats - Developer, Database Administrator, Help Desk, etc., so I know a lot of things but not a lot about one thing. Experts Exchange gives me answers from people who do know a lot about one thing, in a easy to use platform." -Todd S.

Michael WorshamStaff Infrastructure ArchitectCommented:

Experts Exchange Solution brought to you by

Your issues matter to us.

Facing a tech roadblock? Get the help and guidance you need from experienced professionals who care. Ask your question anytime, anywhere, with no hassle.

Start your 7-day free trial
do you have an ethernet cable connected to this interface?
if so just try

ip address interface ethernet1 x.x.x.x x.x.x.x auto
It's more than this solution.Get answers and train to solve all your tech problems - anytime, anywhere.Try it for free Edge Out The Competitionfor your dream job with proven skills and certifications.Get started today Stand Outas the employee with proven skills.Start learning today for free Move Your Career Forwardwith certification training in the latest technologies.Start your trial today

From novice to tech pro — start learning today.