cisco 1841 t1 bonding

Hello I have pair of Cisco 1841 routers currently connected via HDLC over a serial 1t v.35 to an addtran csu/dsu on a T1 line. The addtran is providing 1/2 of the T1 line to our phone system, and the rest to the 1841 for data.

This was not enough bandwidth for our application so I ordered an additional  T1 point to point and two new t1 WICs for the routers.  

Is there a way to "bond" the existing serial 1t wics with the new t1 wics to get the bandwidth of the current 1/2 T1 plus the full bandwidth of the new T1?
Thanks



 
tvurtAsked:
Who is Participating?
 
bkepfordConnect With a Mentor Commented:
You can use ppp multilink

interface Multilink1
 ip address 10.0.0.1 255.255.255.252
 ppp multilink
 ppp multilink group 1
!
interface Serial0/0/0
 no ip address
 encapsulation ppp
 no fair-queue
 ppp multilink
 ppp multilink group 1
!
interface Serial0/1/0
 no ip address
 encapsulation ppp
 ppp multilink
 ppp multilink group 1

Open in new window

0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.