groote
asked on
3com 48 port switch dead?
Hey there, I had a 3com 48 port switch (4250t) go down and the 49th port (uplink) is flashing green and orange. I can't connect to this thing at all and I'm going to lose it. I've tried every hyper terminal setting possible to go serial to serial and rj-45 to serial.
I'm not sure what I need to do to get into this thing, I just want to try a firmware upgrade before I trash it.
I'm not sure what I need to do to get into this thing, I just want to try a firmware upgrade before I trash it.
I do not think you can set these back to factory from the front panel but there may be a reset switch in the back. I would try a hard reset first see if you could connect via Hypertrm then.
ASKER
nothing on the switch that will allow me to do that :(
Also I believe those puppies have a lifetime warranty so don't trash it! 8)
....or, I'll give 2 buck for it! 8)
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.