Networking Hardware-Other
--
Questions
--
Followers
Top Experts
These are the basic steps have taken
core switch#configure terminal
core switch(config)#monitor session 1 source interface fastethernet 0/2 (server port)
core switch(config)#monitor session 1 destination interface fastethernet 0/3 (port connected to my laptop)
I have installed and downloaded wireshark to my laptop
At the moment I cannot see any traffic from the server's Ip address in the traffic capture displayed by wireshark so I assume I have not configured this correctly
Any help would be appreciated
Zero AI Policy
We believe in human intelligence. Our moderation policy strictly prohibits the use of LLM content in our Q&A threads.
show monitor session 1
output from cisco
do you switched on promissious mode when capturing traffic in wireshark?
Idiotically before monitoring the core switchports I set up a capture on one os our access switches as a test.
All appears to be working - it's just a case of filtering the data, BTW what is promissious mode in Wireshark?
EARN REWARDS FOR ASKING, ANSWERING, AND MORE.
Earn free swag for participating on the platform.
Networking Hardware-Other
--
Questions
--
Followers
Top Experts
Networking hardware includes the physical devices facilitating the use of a computer network. Typically, networking hardware includes gateways, routers, network bridges, modems, wireless access points, networking cables, line drivers, switches, hubs, and repeaters. But it also includes hybrid network devices such as multilayer switches, protocol converters, bridge routers, proxy servers, firewalls, network address translators, multiplexers, network interface controllers, wireless network interface controllers, ISDN terminal adapters and other related hardware.