troubleshooting Question

adding route to cisco router (2600)

Avatar of Ekuskowski
Ekuskowski asked on
Routers
9 Comments1 Solution535 ViewsLast Modified:
Our network is curtrently laid out as follows:

We are a windows network Active Directory Server 2003. Our main network is 192.168.1.X and we remote office's connected via point to point T1 lines. all colapsing back to our main Cisco router which is a Cisco 2600 router and also our gateway 192.168.1.1.

Our remote locations are 192.168.10.X, 192.168.20.X and 30.X.

We are now setting up a VMware ESX 3.5 environment. Which will be located at the same physical location as our 192.168.1.X network. We have purchased 4 HP DL380 Servers, Dell Equalogic PS5000X SAN, and two DELL 5448 Switches.

The SAN, 4 Servers and Switches will be on another network segment 192.168.40.X
Each of the four servers have a QLogic Iscsi card to connect to the Switch and talk to the SAN.
The onboard NIC's will comunicate with the 192.168.1.X network

we now need a way for the 192.168.40.X network to connect to the 192.168.1.X network.

We were thinking of running a patch cable from a free port on a WIC card on the CISCO 2600 router to a port on the 192.168.40.X network. Then we can setup a route on the router from the 192.168.1.X network to the 192.168.40.X network.

Can someone tell me how to make the configuration change on the router? I'm far from a Cisco Admin. I know how to connect to the router via Telnet and login and I know the enable password and have the rights to make changes. I just need some pretty detailed instruction on how to make the change.

I printed my Roter config using "sh config"  I beleive we were using a Dual WIC card for a point to point connection at one time, but it has been disabled since.

The show config for that port is as follows:
interface Serial0/1:0
 description Dual T1-port1
 bandwidth 1500
 no ip address
 encapsulation ppp
 no ip route-cache cef
 no ip route-cache
 no fair-queue
 ppp multilink
!
interface Serial0/2:0
 description Dual T1-Port2
 bandwidth 1500
 ip address 192.168.179.1 255.255.255.0
 encapsulation ppp
 no ip route-cache cef
 no ip route-cache
 service-policy output CitrixToRemote

Please let me know if more info from the config file is necessary
Join the community to see this answer!
Join our exclusive community to see this answer & millions of others.
Unlock 1 Answer and 9 Comments.
Join the Community
Learn from the best

Network and collaborate with thousands of CTOs, CISOs, and IT Pros rooting for you and your success.

Andrew Hancock - VMware vExpert
See if this solution works for you by signing up for a 7 day free trial.
Unlock 1 Answer and 9 Comments.
Try for 7 days

”The time we save is the biggest benefit of E-E to our team. What could take multiple guys 2 hours or more each to find is accessed in around 15 minutes on Experts Exchange.

-Mike Kapnisakis, Warner Bros