Cisco Switch 2948G on CAT OS - How do I change speed and duplex of a port
Hi...
Cisco Switch 2948G on CAT OS - How do I change speed and duplex of a port
The port number is 41
and I want to set it to Speed = 100 Duplex = Full
Cheers
Ian
Cisco Switch 2948G on CAT OS - How do I change speed and duplex of a port
The port number is 41
and I want to set it to Speed = 100 Duplex = Full
Cheers
Ian
Last Comment
ASKER CERTIFIED SOLUTION
THIS SOLUTION IS ONLY AVAILABLE TO MEMBERS.
View this solution by signing up for a free trial.
Members can start a 7-Day free trial and enjoy unlimited access to the platform.
Yes, verify the port name though (sh run). I haven't worked on a 2948 in a very long time and can't remember the interface numbering scheme.
Be aware that the other end of the connection also needs to be hard set to 100/Full and the switchport will bounce when you make the change.
ASKER
Cheers
Switches / Hubs
A switch is a device that filters and forwards packets of data between LAN segments. Switches operate at the data link layer or the network layer of the Open Systems Interconnection (OSI) Reference Model and therefore support any packet protocol. LANs that use switches to join segments are called switched LANs or, in the case of Ethernet networks, switched Ethernet LANs. A hub is a connection point for devices in a network. Hubs are commonly used to connect segments of a LAN. A hub contains multiple ports; when a packet arrives at one port, it is copied to the other ports so that all segments of the LAN can see all packets.
23K
Questions
--
Followers
--
Top Experts
Get a personalized solution from industry experts
TRUSTED BY
ASKER
Switch#
Switch#config t
Switch#(config)set port speed fa41 100
Switch#(config)set port duplex fa41 full
Is that correct ?