• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 643
  • Last Modified:

Failed Drive Compaq dl360 array configuration RAID 1+0

I had a drive fail in a mirror.
I replaced the failed drive and the server reported that it was rebuilding the mirror.

But the Compaq Array Confuration Utility never completes the refresh see pic.  And the new driver has never stopped blinking orange.

This server has been doing this for the last 2 weeks.
arrayconfig.jpg
0
ehetzel
Asked:
ehetzel
  • 2
  • 2
1 Solution
 
andyalderSaggar makers bottom knockerCommented:
Looks normal to me.

If you close the ACU does it stop blinking?
0
 
ehetzelAuthor Commented:
Thank you for the posting.  This server is at a remote site and they are not working today.
I will close ACU and have them check the drive status light on Monday, i will post the results.
0
 
andyalderSaggar makers bottom knockerCommented:
Reason I asked to come out of the ACU is that the red light flashes to locate disks as well as indicate failure so with the controller highlighted as shown all disks connected to it will flash.
0
 
ehetzelAuthor Commented:
All lights are green and they are solid. after ACU software was closed.
0

Featured Post

Free Tool: Subnet Calculator

The subnet calculator helps you design networks by taking an IP address and network mask and returning information such as network, broadcast address, and host range.

One of a set of tools we're offering as a way of saying thank you for being a part of the community.

  • 2
  • 2
Tackle projects and never again get stuck behind a technical roadblock.
Join Now