[Okta Webinar] Learn how to a build a cloud-first strategyRegister Now

x
  • Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 282
  • Last Modified:

Cisco NAT and Routing help!

im trying to configure my cisco router to router internet traffic (static IP) to my VLAN1, i have the pulic IP setup under the Ethernet0 and have routing pointed at the ISP's default gateway.

I can ping any internet address from within the routers internal Ping command, but i cannot get internet access on on any of my workstations.  I am very new to Cisco but this doesnt seem to complex, anyone have any ideas?
0
extreme-geeks
Asked:
extreme-geeks
1 Solution
 
basselnehmeCommented:
using Cisco SDM.
go to NAT
follow the basic nat wizard
0
 
DonbooCommented:
interface eth0
ip nat outside

interface vlan1
ip nat inside

ip nat inside source route-map NAT interface Ethernet0 overload

ip access-list extended NAT-LIST
 permit ip 10.10.10.0 0.0.0.255 any

route-map NAT permit 10
 match ip address NAT-LIST

Just replace 10.10.10.0 0.0.0.255 with your internal network.
0
 
extreme-geeksAuthor Commented:
Thanks
0

Featured Post

Veeam and MySQL: How to Perform Backup & Recovery

MySQL and the MariaDB variant are among the most used databases in Linux environments, and many critical applications support their data on them. Watch this recorded webinar to find out how Veeam Backup & Replication allows you to get consistent backups of MySQL databases.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now