• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 469
  • Last Modified:

Configuring HWIC-1ASDL on a Cisco 2811

Hi
I have just installed a 1ADSL card into my 2811 Cisco Router. I am now trying to configure it. I have installed it in the HWIC1 slot of the router. I have been trying to config the card by typing

interface atm0/3/0

Each time I enter the above it says invalid input. Does anyone shed some light on this please?

I have also trying to enter the below config and it will not accept the first line? Error 'Invalid input'
Thank you.

interface Vlan1
 description *** Customer Local Area Connection ***
 ip address 192.168.1.254 255.255.255.0
 --More--          ip nat inside
 no ip virtual-reassembly
 ip tcp adjust-mss 1452

Open in new window

0
XpertTaxis
Asked:
XpertTaxis
  • 2
1 Solution
 
XpertTaxisAuthor Commented:
I have attached below the IOS of the router. Maybe this might not be good enough to reconzise the ASDL card?
Cisco IOS Software, 2800 Software (C2800NM-IPVOICE-M), Version 12.3(8)T7, RELEAS
E SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Sat 12-Mar-05 10:28 by ccai
 
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
 
XpertTaxis uptime is 14 minutes
System returned to ROM by reload at 15:15:50 UTC Tue Feb 17 2009
System image file is "flash:c2800nm-ipvoice-mz.123-8.T7.bin"
 
Cisco 2811 (revision 53.50) with 251904K/10240K bytes of memory.
Processor board ID FCZ110170X6
2 FastEthernet interfaces
1 Serial(sync/async) interface
1 Channelized E1/PRI port
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62592K bytes of ATA CompactFlash (Read/Write)
 
Configuration register is 0x2102

Open in new window

0
 
thesherminatorCommented:
XpertTaxis,

A 2811 will support 'inteface vlan 1' command only if you have got an onboard 16 port switch as the NM. If you have an external switch, you should be creating subinterfaces on fa 0/0 or fa 0/1 and creating subinterfaces as dot1q trunks.

example
interface fa 0/0.1
encapsulation dot1q 1
ip address 192.168.1.254 255.255.255.0

Also regarding your ADSL card, I know for sure the 2811 has support for the ADSL card. Please upgrade IOS to 124-something or higher. You have enough RAM/flash for the upgrade


0
 
thesherminatorCommented:
Cisco website recommends a minimum of  12.4(4)T Base for support of this card on the 2811 platform
0

Featured Post

What does it mean to be "Always On"?

Is your cloud always on? With an Always On cloud you won't have to worry about downtime for maintenance or software application code updates, ensuring that your bottom line isn't affected.

  • 2
Tackle projects and never again get stuck behind a technical roadblock.
Join Now