• Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 736
  • Last Modified:

Sonic wall pro 1260

I have a question. I have work with the TZ190 sonic walls but not the pro 1260. I have a wan connection with a range of 8 usable IP's.  I'm trying to setup differnt ips from the range to different services on differnt computers within my lan. I can't not figure this out. I can setup services but only if I use the wizard and use the ip attached to the wan interface but I have x.x.x.230 - x.x.x.238 and would like to use all the IP's in this usable range. SO in simple terms lets say my wan ip is x.x.x.230 and i want to setup a http port forward. I don't know how to setup http to use x.x.x.232.
0
webiis
Asked:
webiis
1 Solution
 
dpk_walCommented:
Do you have standard or enhanced OS; with standard OS you would be able to configure one-to-one NAT for the incoming traffic; with this one single public IP would be dedicated to one single internal machine.

If you have enhanced OS you get lot of granularity while configuring NAT.

To configure one-to-one NAT, follow the steps below:
1. Goto Network > One-to-One NAT page.
2. Select the Enable One-to-One NAT check box.
3. Click Add. Enter private address of server.
4. Enter public address of server [x.x.x.232].
5. Enter 1.
6. Click OK; click Apply.

For access rule:
Click Firewall, then Access Rules.
Click Add.
Configure the following settings:
1. Allow
2. Service - HTTP
3. Source - WAN
4. Destination - LAN private IP of server

Please note indicating WAN/LAN is important.

Please check and update.

Thank you.
0

Featured Post

Vote for the Most Valuable Expert

It’s time to recognize experts that go above and beyond with helpful solutions and engagement on site. Choose from the top experts in the Hall of Fame or on the right rail of your favorite topic page. Look for the blue “Nominate” button on their profile to vote.

Tackle projects and never again get stuck behind a technical roadblock.
Join Now