Link to home
Start Free TrialLog in
Avatar of mis-uwhpwatertown
mis-uwhpwatertownFlag for United States of America

asked on

I am using a Linksys WUSB600N wirless adapter and I am wondering if the b and g can be disabled and only use the N standard?

I am using the new Cisco N wireless acces point and I am using a Linksys WUSB600N adapter to connect to it.  I need a way to make sure the LInksys WUSB600N always transmits/receives on the N standard and also it needs to only connect to this access point.  As I have ohter access points in my building.
ASKER CERTIFIED SOLUTION
Avatar of zpereyo
zpereyo

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of mis-uwhpwatertown

ASKER

What we did was disable the SSID on all other APs other than the AP we wanted to use.  We also clicked advanced under Wireless network properties and un-checked the automatically connect to non-preferred networks.  Then, we uninstalled the linksys management software and are only using the driver for the linksys usb wlan adapter.  Windows is managing the adapter just fine.  Thanks for your help.