eshurak
asked on
InfoView sporadically gives "The page cannot be displayed" message.
Hello Experts,
I'm using CR2008. Our users access the reports via InfoView. This a very large report containing 10 subreports. Sometimes it runs sometimes it gives a "The page cannot be displayed" message on InfoView. It always runs fine when I run it from CR2008 Developer. How can I make it always run?
Thanks
I'm using CR2008. Our users access the reports via InfoView. This a very large report containing 10 subreports. Sometimes it runs sometimes it gives a "The page cannot be displayed" message on InfoView. It always runs fine when I run it from CR2008 Developer. How can I make it always run?
Thanks
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I've been looking in the CMC and I've found the services, there are 6 differenct "service catagories" each containing between 5 and 10 services, but I can't find where the timeout limit is. Could you point me in the right direction?