MIO net - works on local wired network with drive mapping but unable ot connect to it on the wireless network
I have the following network
192.168.xxx.1 router - wireless gateway - netgear Rangemax WPN824
192.168.xxx.13 Mionet world access drive
When connected to the hard wire cable
IP address of the machine 192.168.xxx.17
I can connect via mionet and via the IP address to shared folder on the drive
I can access the drive management via IP address through any browser
When connecting from the wireless
ip Address changes to 192.168.xxx.21
I can connect with Mionet some times however often shows the drives as failed to mount
I cannot access the drive management via browser (neither firefox or IE)
Please help
Wireless Networking
Last Comment
su2117
8/22/2022 - Mon
su2117
ASKER
I See no one even attempted this
So I put a sniffer on the machine and found the following
Please note I am using a Netgear RangeMax N824 wireless router
the IP protocol packet types seen between the NAS drive and the PC are
1700 - 1709
1641 - 1647
5432
3700 - 3750
3500-3510
2658-2750
I have tried adding a service with these port number and still no connection
I am about to reset the network router and make it unsecured and see if that helps
Any knowledge on Netgear router setup would be much appreciated
Thanks
Subi
su2117
ASKER
Solution given by some one outside the experts exchange - what should I do
So I put a sniffer on the machine and found the following
Please note I am using a Netgear RangeMax N824 wireless router
the IP protocol packet types seen between the NAS drive and the PC are
1700 - 1709
1641 - 1647
5432
3700 - 3750
3500-3510
2658-2750
I have tried adding a service with these port number and still no connection
I am about to reset the network router and make it unsecured and see if that helps
Any knowledge on Netgear router setup would be much appreciated
Thanks
Subi