Output Drops

I have a verizon TLS circuit that is a PTP to another location. We replicate data from our office to the other location so the link is pretty much all data going from location A to location B.
The line is always around 50% utilization but i am getting a good amount of drops. Any Suggestions?
Below is a show int about a min after i cleared counters and the line never was above 50% utilization

FastEthernet0/1 is up, line protocol is up
  Hardware is Gt96k FE, address is 000d.28c5.5f31 (bia 000d.28c5.5f31)
  Internet address is 172.16.1.1/30
  MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
     reliability 255/255, txload 141/255, rxload 26/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 10Mb/s, 100BaseTX/FX
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:02, output 00:00:00, output hang never
  Last clearing of "show interface" counters 00:01:09
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 163
  Queueing strategy: fifo
  Output queue: 0/40 (size/max)
  5 minute input rate 1035000 bits/sec, 636 packets/sec
  5 minute output rate 5534000 bits/sec, 740 packets/sec
     45117 packets input, 9235235 bytes
     Received 16 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog
     0 input packets with dribble condition detected
     52723 packets output, 49216017 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets

Select allOpen in new window