David_Bell20
asked on
Multicasting with 6509 core switch and 3750 edge switches
Hi everybody.
I have a 6509 core switch and assoxiated routers, the switch is running Catos :-(
I'm trying to configure the core switch, associated routers and edge 3750 to support Vocera multicast traffic.
So far I have been able to multicast only with 2 Vocera badges connected to an AP which is directly connected to the core switch, I seem unable to enable the multicast traffic anywhere else!
I am very interested in learning if config is required on any edge switches?
Vocera recommend disabling IGMP snooping, however the only command I can see in CATOS is 'set igmp disable' which turns ALL IGMP off I believe? I think I need to have IGMP enabled, and IGMP snooping disabled.
Could anybody advise me the best way to configure this please?
Thanks!
I have a 6509 core switch and assoxiated routers, the switch is running Catos :-(
I'm trying to configure the core switch, associated routers and edge 3750 to support Vocera multicast traffic.
So far I have been able to multicast only with 2 Vocera badges connected to an AP which is directly connected to the core switch, I seem unable to enable the multicast traffic anywhere else!
I am very interested in learning if config is required on any edge switches?
Vocera recommend disabling IGMP snooping, however the only command I can see in CATOS is 'set igmp disable' which turns ALL IGMP off I believe? I think I need to have IGMP enabled, and IGMP snooping disabled.
Could anybody advise me the best way to configure this please?
Thanks!
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I have resolved this now.
In the end the problem was I hadn't configured multicasting on the AP management vlan.
I struggled with the core being catos, still not sure igmp is working as it should be though. 'no ip igmp snooping' is an IOS command, hence I am still not convinced that igmp snooping is disabled.
So - one last question folks - how so I disable igmp snooping in CATOS?
Thanks for the responses, both are very helpful.
Regards