Solved

Cisco Router Multilink PPP verify bandwidth

Posted on 2009-03-31
3
702 Views
Last Modified: 2012-05-06
I have a pair of T1's that connect two of my sites.  I have a cisco router on each end.  I have the 2 T1's bonded together using Multilink PPP.

Is there a Cisco IOS command that will verify that I am getting 3.0 Mbps on that connection?
0
Comment
Question by:drapercity
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
3 Comments
 
LVL 43

Accepted Solution

by:
JFrederick29 earned 500 total points
ID: 24029890
You can look at the 5 minute average:

show int multilink1   <--your multilink interface

Look at the input/output average.
0
 

Author Closing Comment

by:drapercity
ID: 31564871
I was hoping there was a more "elegant" way to test the bandwidth or view the active multilink, but your solution does work and I appreciate the feedback.  -Steve
0
 
LVL 43

Expert Comment

by:JFrederick29
ID: 24088966
You can use any number of bandwidth monitoring apps like MRTG or Cacti if you want to graph the bandwidth utilization historically.
0

Featured Post

Schedule a Tour of the ATEN booth at InfoComm 2017

Tour the ATEN booth to see the the Latest Addition to the Modular Matrix Switch Series, New 4K HDMI Over IP Extender and more! Enter ATEN's Ultimate Giveaway Sweepstakes for a chance to win one of several great prizes, including an ATEN US7220 2-Port Thunderbolt 2 Sharing Switch!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

It happens many times that access list (ACL) have to be applied to outgoing router interface in order to limit some traffic.This article is about how to test ACL from the router which is not very intuitive for everyone. Below scenario shows simple s…
In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

728 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question