baytechnical
asked on
have cisco 2821, performed a factory reset, enabled port 0/0 and set ip address etc. Enabled http, hhtps, unable to connect using cisco sdm. stops at splash screen. Does anyone have any ideas?
have cisco 2821, performed a factory reset, enabled port 0/0 and set ip address etc. Enabled http, hhtps, unable to connect using cisco sdm. stops at splash screen. Does anyone have any ideas?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Do you think I should try the Cisco Configuration Professional client? Will this function with the sdm on the router?
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER