Solved

Cisco ASA Firewall 5510 and Cisco router 2600

Posted on 2009-04-02
2
290 Views
Last Modified: 2012-05-06
Hi,
I have just purchased two second hand cisco devices:

Cisco ASA Firewall 5510
Cisco router 2600

 neither have any flash cards installed so I am guessing that they will not work without these. I was just looking for advice if these devices are any good, any how I go about buying the right flash cards and IOS's for them

Thanks
0
Comment
Question by:Dan560
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 8

Accepted Solution

by:
Nothing_Changed earned 500 total points
ID: 24049313
Neither one requires a "flash card". the 2600 is old and past end of life. the 5510 is brand new-ish, and probably the best firewall on the market. both have NVRAM built onboard for both software images and config files.
0
 
LVL 2

Author Comment

by:Dan560
ID: 24050612
thanks!
0

Featured Post

Is your NGFW recommended by NSS Labs?

Ours is! NSS Labs Next Generation Firewall Test gives the WatchGuard Firebox M4600 a "Recommended" rating! Curious where your NGFW landed on the  Security Value Map? See the map and download the full report today!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
I recently attended Cisco Live! in Las Vegas, a conference that boasted over 28,000 techies in attendance, and a week of hands-on learning hosted by a solid partner with which Concerto goes to market.  Every year, Cisco displays cutting-edge technol…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

729 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question