[Webinar] Streamline your web hosting managementRegister Today

x
  • Status: Solved
  • Priority: Medium
  • Security: Public
  • Views: 300
  • Last Modified:

Extend 3com NBX over T1 Point-to-Point with Cisco 1721

Is there a way to extend a 3com nbx system over a point-to-point t1 line? i have two cisco 1721 (with csu/dsu wic), one for each end... there will be no other traffic over this line. it is for phone only. any help or hints would be greatly appreciated.
0
kommgroup
Asked:
kommgroup
  • 2
1 Solution
 
kommgroupAuthor Commented:
would terayon bwx1 units do the job better than the cisco 1721? does anyone have any familiarity with the bwx1?
0
 
kommgroupAuthor Commented:
I have resolved this by setting up the cisco 1721 units in transparent bridging mode (use the following config on both):

conf t
config-register 0x2102
no ip routing
bridge 1 protocol ieee
interface serial0
bridge-group 1
no shutdown
exit
interface fastethernet0
bridge-group 1
no shutdown
end

be sure to save to startup config:

copy run start
0

Featured Post

Evaluating UTMs? Here's what you need to know!

Evaluating a UTM appliance and vendor can prove to be an overwhelming exercise.  How can you make sure that you're getting the security that your organization needs without breaking the bank? Check out our UTM Buyer's Guide for more information on what you should be looking for!

  • 2
Tackle projects and never again get stuck behind a technical roadblock.
Join Now