Solved

How do i configure my cisco 877 on bridge mode

Posted on 2009-04-05
4
784 Views
Last Modified: 2012-05-06
How do I configure my Cisco 877 router on bridge mode.
0
Comment
Question by:vijaydawda
  • 2
4 Comments
 
LVL 11

Accepted Solution

by:
manav08 earned 125 total points
ID: 24071052
0
 
LVL 1

Author Comment

by:vijaydawda
ID: 24071206
Hi,
Thks. for quicky reply,  I Tried but it does not get through,  I have one more choice, that is configure this as nat router then pass all incoming connection on one of the internal ( LAN) IP, infact I want to do VPn with this router & fortinet at one end & other end has fortinate with leased line
 
could I get NAT config for 877 router?
 
Thanks in advance
 
0
 
LVL 50

Expert Comment

by:Don Johnston
ID: 24071267
> I Tried but it does not get through,

What does this mean? Does it not accept the commands? Can you post the current config please.

As for NAT and VPN, what version and feature set is your IOS?
0
 
LVL 11

Assisted Solution

by:manav08
manav08 earned 125 total points
ID: 24071269
use the following command -
ip nat inside source static tcp 10.0.10.239 80 128.147.165.57 80 extendable

i.e.
ip nat inside source static tcp (Internal Server IP Address) (port) (Static IP provided by ISP) (incoming port) extendable
0

Featured Post

Threat Intelligence Starter Resources

Integrating threat intelligence can be challenging, and not all companies are ready. These resources can help you build awareness and prepare for defense.

Join & Write a Comment

Suggested Solutions

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

744 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

11 Experts available now in Live!

Get 1:1 Help Now