mjinxed
asked on
Trouble acessing NetGear WAP with TFTP - OK in HyperTerminal
This is actually a continuation of this question:
https://www.experts-exchange.com/questions/24286489/Netgear-WAP-WG302-Cannot-access-after-firmware-upgrade.html
I guess I shouldn't have closed it so soon.
A firmware update casued it to be unreachable via IP adress.
I am able to see the unit functioning via a null modem cable and the output result are attached as a txt file.
So, it's "alive".
I had tried to follow instructions on using TFTP to re-flash the fiirmare. It simply isn't working. I can check Windows Firewall to see if port 69 is open I suppose.
Anyway, the WAP appears to be OK. I can login to the unit and it doesn't reboot, etc...
Ideally, I'd just like to be able to assign it an IP via command line within HyperTerminal.
Is this possible?
If not- what else can I do?
netgear.txt
https://www.experts-exchange.com/questions/24286489/Netgear-WAP-WG302-Cannot-access-after-firmware-upgrade.html
I guess I shouldn't have closed it so soon.
A firmware update casued it to be unreachable via IP adress.
I am able to see the unit functioning via a null modem cable and the output result are attached as a txt file.
So, it's "alive".
I had tried to follow instructions on using TFTP to re-flash the fiirmare. It simply isn't working. I can check Windows Firewall to see if port 69 is open I suppose.
Anyway, the WAP appears to be OK. I can login to the unit and it doesn't reboot, etc...
Ideally, I'd just like to be able to assign it an IP via command line within HyperTerminal.
Is this possible?
If not- what else can I do?
netgear.txt
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.