Solved

Sonicwall - Pix Conversion

Posted on 2009-04-09
2
371 Views
Last Modified: 2012-06-21
We are converting from an old PIX to a SonicWalll 2400 which is using Enhanced OS

Our current Pix has an IP address of 10.10.0.2
We have a VOIP phone system.

Our Data Network has an IP address schema  of 10.10.0.xxx with the gateway of 10.10.0.1 residing on a layer three switch

Our Voice Network (VOIP)  has an IP address schema of 10.10.2.xxx with the gateway of 10.10.0.2 residing on the layer three switch.  

We have a command in the pix to route the traffic "Route Inside 10.10.2.0 255.255.255.0 10.10.2.1 1" which we are trying to covert over to our SonicWall.


Thanks
0
Comment
Question by:MainSail2007
2 Comments
 
LVL 9

Accepted Solution

by:
hmare earned 500 total points
ID: 24109671
In sonicwall enhanced, you create objects for each subnet or device, and add a rule under network> routes that sends that object out on a specific interface, to your gateway (which is also an object)

Objects are created under network> objects

So, you create an object that is 10.10.2.0, name it VOIP.
create the rule, (policy) so that VOIP goes to whichever interface, and the gateway is 10.10.2.1(or whatever the next hop is after the interface)

0
 

Author Comment

by:MainSail2007
ID: 24130019
Thanks
0

Featured Post

Is Your Active Directory as Secure as You Think?

More than 75% of all records are compromised because of the loss or theft of a privileged credential. Experts have been exploring Active Directory infrastructure to identify key threats and establish best practices for keeping data safe. Attend this month’s webinar to learn more.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Guest Wi-Fi Marketing solution required 8 58
Cisco ASDM device NT domain question 4 30
Trunk and Port Security 4 38
Cost effective dual wan w/ qos 5 22
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

939 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question