Updating WAP11 firmware

I have 2 Linksys WAP11's.... I tried updating the firmware on them, it completed without error. However, they are now non responsive, I cannot use them and cannot even get to a setup page. I have reset them several times by holding the reset button over a minute. I cannot access them via the default IPs or my own manual ips. Any ideas before I toss them?
wonker2Asked:
Who is Participating?

Improve company productivity with a Business Account.Sign Up

x
 
johnb6767Connect With a Mentor Commented:
Do they power up at least?

Try using this to upgrade the firmware once again, and verify your Version number once again.....

ftp://ftp.linksys.com/pub/network/tftp.exe

This method doesnt need a login to the device.... If it doesnt respond this way, and you have tried a reset by using the button (which you have), then I am afraid they might have been bricked..... In teh event of multiple ones, I would call thier support. You might have found a bug in thier code.....

Use the following to scan your subnet, to see if you can identify them by name...

What is Angry IP Scanner?
http://www.angryziber.com/w/Home
0
 
wonker2Author Commented:
It was a no go..  they are in the trash... Even Linksys couldn't get them going... so a note to others, apply the firmware at your own risk... I just lost 2 AP's because of it.
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.