Solved

How can I relay smtp email in Exchange 2007

Posted on 2009-04-09
2
446 Views
Last Modified: 2013-11-30
I have a scanner\fax machine on my network that emails exchange via smtp. It works ok if the address is internal, but it cannot email externally. Its IP address is listed in my Receive Connector on the CAS under Network\Receive from remote servers. Do I have to add it elsewhere for external relaying? Thank you.
0
Comment
Question by:cyberleo2000
2 Comments
 
LVL 6

Expert Comment

by:mickeyfan
ID: 24111171
0
 
LVL 8

Accepted Solution

by:
big_daddy0690 earned 500 total points
ID: 24112013
If the scanner\fax machine is using anonymous authentication then you will need to:

  1. Specify login credentials for the scanner\fax machine to use or
  2. Change the permissions on the receive connector to allow anonymous users to relay to any recipient. (Note: Make sure you trust the IP Addresses specified within the receive connector as this can be a security risk.)
To add the permission to the receive connector you need to use the Exchange Management Shell and run the following command. (see attachment)

ShellCommand.txt
0

Featured Post

Best Practices: Disaster Recovery Testing

Besides backup, any IT division should have a disaster recovery plan. You will find a few tips below relating to the development of such a plan and to what issues one should pay special attention in the course of backup planning.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Most of the applications these days are on Cloud. Cloud is ubiquitous with many service providers in the market. Since it has many benefits such as cost reduction, software updates, remote access, disaster recovery and much more.
This article will inform Clients about common and important expectations from the freelancers (Experts) who are looking at your Gig.
To show how to generate a certificate request in Exchange 2013. We show this process by using the Exchange Admin Center. Log into Exchange Admin Center.:  First we need to log into the Exchange Admin Center. Navigate to the Servers >> Certificates…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

820 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question