Solved

Cisco 2948G Will not allow Config T

Posted on 2009-04-09
2
864 Views
Last Modified: 2012-05-06
I just got a Cisco Catalyst 2948G Switch.  I did a Clear Config All to reset it.  Now, when I type in Config T, I receive the following message:

This function provided by set commands.  Use 'set help' for more info.

Does anyone know what I need to do to resolve this?  I've also set the IP and gateway for the switch.  Also, I believe there's a web GUI for this switch, would anyone know how to enable it?  
Any help would be appreciated with this
0
Comment
Question by:crobotti
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 20

Accepted Solution

by:
RPPreacher earned 500 total points
ID: 24113152
Your 2948G is using Cat OS not IOS.

Here's a reference for CAT OS

https://www.cisl.ucar.edu/nets/presentations/training.topics/catos-vs-ios.pdf
0
 

Author Comment

by:crobotti
ID: 24115165
I believe the Switch also has a Web GUI.  Any idea how to configure\access this?

Thanks
0

Featured Post

[Webinar] Learn How Hackers Steal Your Credentials

Do You Know How Hackers Steal Your Credentials? Join us and Skyport Systems to learn how hackers steal your credentials and why Active Directory must be secure to stop them. Thursday, July 13, 2017 10:00 A.M. PDT

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I eventually solved a perplexing problem setting up telnet for a new switch.  I installed a new Cisco WS-03560X-24P switch connected to an existing Cisco 4506 running a WS-X4013-10GE Sup II-Plus. After configuring vlans and trunking,  I could no…
WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
Michael from AdRem Software outlines event notifications and Automatic Corrective Actions in network monitoring. Automatic Corrective Actions are scripts, which can automatically run upon discovery of a certain undesirable condition in your network.…
This is my first video review of Microsoft Bookings, I will be doing a part two with a bit more information, but wanted to get this out to you folks.

630 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question