?
Solved

juniper Netscreen 5gt

Posted on 2009-04-10
2
Medium Priority
?
325 Views
Last Modified: 2012-05-06
I  recently purchased the Netscreen 5gt device off of ebay. I had no prior experience with the device before this. My ? is. I recently opened up some service ports IE: smtp =25 ftp 21. Anyway, when I run a port scan from the internet (audit my pc), the ports show up as open. Is this normal? Should these open ports be visible? I used to have the Watchguard soho 6 with same ports open, and the ports would never show up during the scan. I just want to make sure I have this configured correctly.
0
Comment
Question by:markstep1
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 70

Accepted Solution

by:
Qlemo earned 300 total points
ID: 24121345
Yes, that is "normal", as long as you opened that ports for "Untrust to Trust", and the ports are forwarded to corresponding services in your network.
0
 

Author Closing Comment

by:markstep1
ID: 31568929
Sweet! thanksfor the clarification.
0

Featured Post

Optimum High-Definition Video Viewing and Control

The ATEN VM0404HA 4x4 4K HDMI Matrix Switch supports 4K resolutions of UHD (3840 x 2160) and DCI (4096 x 2160) with refresh rates of 30 Hz (4:4:4) and 60 Hz (4:2:0). It is ideal for applications where the routing of 4K digital signals is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In this tutorial I will show you with short command examples how to obtain a packet footprint of all traffic flowing thru your Juniper device running ScreenOS. I do not know the exact firmware requirement, but I think the fprofile command is availab…
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

800 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question