Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people, just like you, are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
Solved

Upgraded router IOS, getting MMI errors.  No modem installed and I'm not sure where the commands are coming from.

Posted on 2009-04-11
2
949 Views
Last Modified: 2012-05-06
I upgraded my cisco 2801 router from advanced security IOS to advanced enterprise IOS last night.  Now when I reload I get the 'invalid input' errors below.  I don't have any mmi commands listed in my running-config.  Further there isn't a modem installed on this router.   I'm not sure where the commands are coming from.  Is this part of the advanced enterprise services IOS?

Please let me know if you need more details.
Cisco 2801 (revision 5.0) with 235520K/26624K bytes of memory.
Processor board ID FTX0950Z0PV
6 FastEthernet interfaces
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
62720K bytes of ATA CompactFlash (Read/Write)
 
mmi polling-interval 60
^
% Invalid input detected at '^' marker.
 
no mmi auto-configure
   ^
% Invalid input detected at '^' marker.
 
no mmi pvc
   ^
% Invalid input detected at '^' marker.
 
mmi snmp-timeout 180
^
% Invalid input detected at '^' marker.

Open in new window

0
Comment
Question by:bhaidua
2 Comments
 
LVL 79

Expert Comment

by:lrmoore
ID: 24122772
I wouldn't worry about it. These look like some leftover default settings from the previous version. Once you save the config after the reboot, you should not see these errors again.
0
 

Accepted Solution

by:
bhaidua earned 0 total points
ID: 24122824
After running the 'setup' command, re-initializing and saving it to NVRAM it has cleared up the mmi errors.  I'm not sure where they were coming from but they're gone.

Thanks.
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
Creating an OSPF network that automatically (dynamically) reroutes network traffic over other connections to prevent network downtime.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

861 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question