Solved

Cisco 2800 Router

Posted on 2009-04-11
2
694 Views
Last Modified: 2012-05-06
Hi,

I have recently installed a cisco 2800 router on a network I support and also a CIsco 1800 in a different location. I have configured the 1800 to accept VPN sessions which is workng fine from any location other than If i try to VPN from the location apart from when I try from behind the 2800 network. I think I need to configure an ACL to allow me to VPN out, but not sure how to do that.. Can any one help me wih advise, any will be appriecated..

Regards

Darren
0
Comment
Question by:dazzzor
2 Comments
 
LVL 6

Accepted Solution

by:
cosmicfox earned 500 total points
ID: 24127577
Are you using nat? if so you will need to bypass nat. So in your nat rule will have to look something like this.

ip nat inside route-map NONAT interface outside overload

route-map NONAT
permit ip address 100

!!first block is local second is remote ip block.

access-list 100 deny ip 10.1.1.x 255.255.255.0 10.2.2.x 255.255.255.0    
access-list 100 permit ip any any
0
 

Author Closing Comment

by:dazzzor
ID: 31569215
thank you
0

Featured Post

Threat Intelligence Starter Resources

Integrating threat intelligence can be challenging, and not all companies are ready. These resources can help you build awareness and prepare for defense.

Join & Write a Comment

Overview The Cisco PIX 501, PIX 506e, ASA 5505 and ASA 5510 (most if not all of this information will be relevant to the PIX 515e but I do not have a working configuration handy to verify the validity) are primarily used within small to medium busi…
This article assumes you have at least one Cisco ASA or PIX configured with working internet and a non-dynamic, public, address on the outside interface. If you need instructions on how to enable your device for internet, or basic configuration info…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

747 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

11 Experts available now in Live!

Get 1:1 Help Now