Solved

cisco asa ssm 5.1 password recovery

Posted on 2009-04-15
2
816 Views
Last Modified: 2012-05-06
I have a cisco asa running v. 8.0(4)28 and the ssm is v 5.1(6)E1.

I forgot the username and password for the module and since it's v5.1 it can't use the password recovery method of:

# hw-module module 1 password-recovery

Any ideas on how to reset the module to factory default?  I don't care about the config.
0
Comment
Question by:intlbizman84
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 16

Accepted Solution

by:
2PiFL earned 250 total points
ID: 24150540
0
 

Author Comment

by:intlbizman84
ID: 24282858
Thanks, I had to reimage the ssm.
0

Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
unable to set full duplex 100 on WAN interface 11 95
IKEv2 on Palo Alto Networks 5050 FW 2 34
SSH setup on ASA 5505 17 116
Tracert fails final hop at some client offices 3 44
Optimal Xbox 360 connectivity requires "OPEN NAT". If you use Juniper Netscreen or SSG firewall products in a home setting, the following steps will allow you get rid of the dreaded warning screen below and achieve the best online gaming environment…
In the world of WAN, QoS is a pretty important topic for most, if not all, networks. Some WAN technologies have QoS mechanisms built in, but others, such as some L2 WAN's, don't have QoS control in the provider cloud.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

737 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question