?
Solved

virtual network issue with Hyper-V

Posted on 2009-04-23
5
Medium Priority
?
259 Views
Last Modified: 2012-05-06
Hi All,

I got 2 gigabit network cards, and they are recognized by the physical server (2008 64bit hyper-v) they get dhcp ip from my router. (no drivers needed)


But when I create a virtual network and assign it to a VM, they are not recognized inside the VM.

I accepted all the default when creating an external virtual network and choose the nic card I wanted to use.

Try to feed it the cd with the drivers, it didnt take.

Am I missing something?

Here is the link for my NIC
http://www.rosewill.com/support/download.aspx?ids=3_39_97_425


Thanks much

nirsky


0
Comment
Question by:STSDSE
  • 3
  • 2
5 Comments
 
LVL 21

Accepted Solution

by:
from_exp earned 500 total points
ID: 24217355
you will need integration services (hyper-v synthetic drivers) inside VM for all your extrernal hardware (scsi adapters, nics, etc)
0
 

Author Comment

by:STSDSE
ID: 24217498
Thanks,
I will try that tonight.
0
 
LVL 21

Expert Comment

by:from_exp
ID: 24217508
please report back after that.
good luck!
0
 

Author Comment

by:STSDSE
ID: 24217837
Sure thing.
And Thank you.
0
 

Author Comment

by:STSDSE
ID: 24222601
It works like a charm.

It was not necessary to install the integration services on Windows 7 32bit.
0

Featured Post

Prep for the ITIL® Foundation Certification Exam

December’s Course of the Month is now available! Enroll to learn ITIL® Foundation best practices for delivering IT services effectively and efficiently.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
This article is in regards to the Cisco QSFP-4SFP10G-CU1M cables, which are designed to uplink/downlink 40GB ports to 10GB SFP ports. I recently experienced this and found very little configuration documentation on how these are supposed to be confi…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
Michael from AdRem Software explains how to view the most utilized and worst performing nodes in your network, by accessing the Top Charts view in NetCrunch network monitor (https://www.adremsoft.com/). Top Charts is a view in which you can set seve…

840 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question