Link to home
Start Free TrialLog in
Avatar of MikeKAtLCS
MikeKAtLCS

asked on

MAS200 Pervasive setup

My server went down when the C: drive ran out of disk space.  Although I was able to save the data on the D partition the C partition was history.  Because I replaced the hardware I am not able to use a system state restore.  It would appear that we stopped doing them anyway since the tape was not big enough to hold all our data and the system state.  So I slipstreamed a server 2000 disk with SP4 and recreated the C partition.  I need to get MAS200 running again but I don't know how to get Pervasive installed and configured.  The only thing I know for sure is that it was using port 10000.  The data is intact since it was on the D partition.  We also use the latest Peachtree which also uses the pervasive server.  I thought I could install the server portion first and the make the changes for MAS200.  That would get pervasive onto the server.
ASKER CERTIFIED SOLUTION
Avatar of MikeKAtLCS
MikeKAtLCS

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial